What is the density of sand and stone Density during towing
Sand and stone are about 2500kg / m3
Different species, different density
RELATED INFORMATIONS
- 1. How to measure the bulk density of stones
- 2. What is the density of sand, stone, cement and water
- 3. Excuse me, what is the bulk density and compact density of sand? Online and so on! What is the bulk density and compact density of medium sand? What is the bulk density and compact density of 5-40mm gravel? What is the bulk density and compact density of 5-40mm pebbles?
- 4. How to calculate the energy flux density, for example,
- 5. What density is used to calculate the density of concrete mix sand
- 6. How to calculate the density of matter, to formula and examples, thank you
- 7. Which density of carbon dioxide is higher than that of air? For example
- 8. 1-2 gravel density (natural accumulation is 1.423, seismic compaction is 1.573) to find out how many tons there are in one side. The meter stone density (natural accumulation is 1.412, seismic compaction is 1.550) is the same as 1.2
- 9. Now we need to prepare M5 mixed mortar, the material is 325 ordinary cement, medium sand (moisture content is 2%, mass density is 1500kg / m3), trial calculation When the discharge capacity of the mixer is 350L, try to calculate the feeding amount of mixing once
- 10. How to calculate the amount of sand in the mortar mix? Is it not the bulk density when it is dry? Why should the moisture content be added The mix proportion of cement lime mortar should meet the requirements of construction workability (consistency), ensure the design strength, save cement as much as possible and reduce the cost. The mix proportion of M7.5 grade cement lime mortar with consistency of 70-100 mm is used for masonry brick wall (1) Materials 1. Cement: 32.5mpa ordinary portland cement; 2. Lime paste: consistency 120mm; 3. Sand: medium sand, with a bulk density of 1450kg / m3 and a water content of 2%; 4. Construction level: General I don't understand the calculation of sand consumption The answer in the book is: according to the sand bulk density and moisture content, calculate the sand consumption QS QS =1450×(1+2%)=1479(kg/m3) But doesn't the amount of sand refer to the bulk density when it is dry? Why should 2% water be added? Isn't it the bulk density when the sand contains water? What's the matter
- 11. Calculation formula of wet density in sand filling test of highway standard test
- 12. How to demarcate the standard sand density in sand filling method
- 13. The square of 2x - 6 = 0 to solve the equation
- 14. Solve the equation: the square of (2x-1) - 4 = 0
- 15. Solve the equation: the square of 2x + X + 3 = 0
- 16. The surface area of this cuboid is () square decimeter, and its volume is () cubic decimeter
- 17. The surface area of the cuboid is () square decimeter and the volume is () cubic decimeter
- 18. Motor, u = 110V, r = 0.4 ohm, normal operation, I = 0.5A, find 1. Work done by current per second, heat generated per second, Q
- 19. The quadratic equation (x-3) ² = 5 is reduced to the general form of (x-3) ² = 5
- 20. When the slide of sliding rheostat moves, the indication of ammeter and voltmeter in the circuit changes