What is the allowable deviation value of subgrade slope? (the code says that it meets the design requirements). There will be some deviation
The deviation shall not exceed 1.5 times of the design value
If the above answers can help you, please click "adopt" Y (^_ ^)Y
RELATED INFORMATIONS
- 1. How many degrees is the 5% road slope? How to calculate it? Please be more detailed
- 2. Calculation method of composite slope in road design
- 3. How to calculate and set out the road slope It is known that the elevation of point a is 0.200, the elevation of point B is 0.000, the distance between two points is 21m, and the slope is 1%. How to use the level to measure the slope and set out
- 4. I need to know the meaning and difference of road slope and longitudinal slope and how to calculate them
- 5. What is the drainage slope ratio of municipal roads? What are the longitudinal and transverse slopes? How to calculate?
- 6. How to calculate the slope of 1:1.2 or 1:1.5
- 7. Please tell me how to draw the slope, the first figure
- 8. The width of the left subgrade, the width of the right subgrade, the filling area and the excavation area in the subgrade cross section are indicated by letters!
- 9. In cross section design of urban road, assuming that the width of subgrade is 43M, how to arrange cross section
- 10. Road width standard It is said that science Avenue in Zhengzhou high tech Zone will continue to be built to the West. The new road is said to be 120 meters wide. Does this meet the national standard? The standards and guidelines (97 Edition) states that: Expressway road width (m) 60-100 Expressway road width (m) 60-80 Main road width (m) 40-60 Width of secondary trunk road (m) 30-40 From: Shenzhen Planning Bureau
- 11. The fill slope is 20 meters long and 5 meters high. According to the gradient of 1:1.5, how much is the volume?
- 12. What is slope gradient?
- 13. How to calculate the slope of fill slope? Is it slope width divided by height?
- 14. Highway slope gradient measurement How to measure the slope of highway slope and what instruments are generally used?
- 15. What is the reason for changing the slope gradient of subgrade excavation from 1:0.5 to 1:1
- 16. How to determine the slope gradient of foundation trench inspection
- 17. Stair step method
- 18. What is the standard requirement of stair step width
- 19. How should stairs and steps be calculated The known conditions are: 1. Residential indoor stairs 2. Plane space 6 square meters (3 meters long and 2 meters wide) 3. Indoor height 3.6 meters Excuse me: 1. Can I make a circular staircase? 2. If I can, how wide should I be? How many steps should I take to get up? What is the best step?
- 20. How does the area of marble of stair step platform calculate? Is 2cm of marble overhanging platform area? If granite is not made at the skirting board (not the skirting line) of the stair step, and the step width is 28cm, how much material should be provided? Please give me more advice