In a three-phase asynchronous motor, how to calculate the rotational speed of the rotor's rotating magnetic field and whether it is the same as that of the rotor?

The rotating speed of the rotor rotating magnetic field is the same as that of the stator rotating magnetic field

What is the rated power of three-phase asynchronous motor?

When the motor runs under rated condition, the mechanical power output on the shaft is called rated power

RELATED INFORMATIONS

1. The rated power of three-phase asynchronous motor refers to
2. What is the definition of electric power
3. Xiao Li's family has a 220V 2000W water heater. The water heater works normally. How many joules does it consume in 5h
4. The rated power of an electric fan is 60W, the internal resistance is 2 Ω, and the rated voltage is 220. If it is connected to the power supply, it can't rotate for some reason. Calculate the current and actual electric power
5. Two resistors R1 and R2 are connected to the circuit in parallel, and the total resistance is 3 ohm, in which R1 = 4 ohm? A. 1 ohm B.7 ohm c.12 ohm D11 / 2
6. In the circuit as shown in the figure, the power supply voltage remains unchanged, and the resistance R2 = 2r1. Suppose that the electric power of resistance R2 is P1 when switch S2 is closed and S1 is open, and the electric power of resistance R2 is P2 when both switches S1 and S2 are closed, then the electric power P1: P2=______ At this time, the electric power of resistance R1 is equal to______ Tile
7. Two resistors, R1 = 12 Ω, R2 = 24 Ω, are connected in series to a 48V power supply. How much power is consumed by R1? (2) How much heat does R1 and R2 produce per minute?
8. There are two resistors in the series circuit. It is known that R1 = 8 Ω, the voltage at both ends of R2 is 4V, and the total voltage of the circuit is 12V. According to these known quantities, what physical quantities can you work out?
9. How to calculate current and voltage when resistance, time and power are known
10. Is the resistance of superconductor zero? According to Ohm's law, I = u / R, r = u / I, if r = 0, isn't this Law meaningless?
11. Power loss of overhead transmission lines P = voltage squared / resistance P = current squared * resistance why in overhead transmission lines, power loss is often reduced by increasing voltage and reducing current, rather than by increasing current and reducing voltage?
12. The voltage at both ends of the resistor increases to twice of the original value, and the work done by the current is several times of the original value in the same power on time
13. Why is the current work formula w = IUT and how is the formula derived
14. Is the hysteresis in power factor λ = 0.866 (hysteresis) current hysteresis voltage or voltage hysteresis current? Symmetrical three phase motor
15. A third day physics power problem! If an electric kettle is marked with the word "220 V 800 W", how much power is consumed when it works normally for 20 minutes? What is the rated current? What is the resistance when it works normally? (for detailed process, speed ~~~~~~~~~~~
16. Which units are the units of electric power and which are the units of electric energy?
17. In terms of physical parameters, should the brightness of the two bulbs be compared by current, voltage or electric power?
18. In parallel circuit (when the voltage is equal), if the power of one bulb is higher than the other, is it brighter than the other There are series circuit, by the way, there are no other factors will affect, also said. Tomorrow on the entrance examination on physics
19. Two lights L1 and L2 are connected in series in the circuit. Is the power of light or dark high? Is it in parallel?
20. Characteristics of electric power in series and parallel circuits